Compex WP54AG User Manual download pdf (Page 5)

WP54 6E

PORTING OpenWRT FIRMWARE OVER TO

WP54 6E

Guide on how to port OpenWRT Firmware over to WP54

Note

1. Your current Compex loader version is V2.4 or above.

2. Please ensure that Ethernet connection is connected and able to Ping

address = 192.168.168.1 .

3. You are in the firmware upgrade mode

==> (By Press and hold the Reset button and plug-in the power adaptor).

Console (CMD/DOS) type command below.

1. Write OpenWrt image to flash.

> tftp -i 192.168.168.1 put flashwrt.cmd

> tftp -i 192.168.168.1 put openwrt-wp54g-2.4-squashfs.trx

(This might takes Up to 1 Minute, So please wait for awhile)

2. Change the partition table to load OpenWrt image format.

> tftp -i 192.168.168.1 put partwrt.cmd

3. Create a default NVRAM partition.

> tftp -i 192.168.168.1 put nvram-crt.cmd

4. Finish and Reboot the AP.

5. To test whether you are successful, in converting to Open-WRT,

Please do followings command in DOS

> telnet 192.168.1.1

a. The picture shows below will appear if you are successful.

b. The first boot time will be a little longer, so please wait for awhile.

1 2 3 4 5 6 7 8 9 10 ... 17 18

No comments

Compex WP54AG User Manual Page 5