WP54 6E Revision: 1.9
9WP54 6E Serial Port Header The Compex WP54 6E Serial Port (J1) Header signaling is shown in the following table. Pin Signal Pin Signal1 VCC – 3
10WP54 6E Serial Console Settings The serial console settings used together with the serial port is given below. This serial port uses TTL signal
11WP54 6E Serial Converter Pin Layouts Cables on the serial converters are provided. You can use the 6 Pin (Fixed) to 4 Pin (Fixed) provided. The
12WP54 6E JTAG Port Header The primary purpose of the Compex WP54 6E JTAG Port Header is to facilitate program download into Flash memory. Pin Sig
13WP54 6E Ethernet Connectors The Compex WP54 6E contains 1 X 10/100 Base-TX Ethernet Channels. The Ethernet Channels are available through stand
14WP54 6E How to Extend Antenna Alignment to Case LED You might want to extend the Antenna Alignment LED to the LED of the case. You just need to
15WP54 6E Additional Notes (For WP54 6E) 1. Major difference between WP54 6E and WP54 1B are that a. WP54 1B can only support 5V DC and 4
16WP54 6E 3. The Open-WRT is based on Linux 2.4. OpenWRT using Linux 2.6 is currently being developed by Compex team. It is also actively being d
17WP54 6E Our current Open-WRT stores configuration files in writable JFFS partition, not in the NVRAM partition. Configuration cannot be saved i
i WP54 6E Table of Contents REVISION HISTORY...2 REASONS USING DEVELOPMENT KIT
2WP54 6E REVISION HISTORY Revision Information / Changes Rev 1.1 First release for WP54 6E/ WP54 WRT6E BareBoard Rev 1.2 Added 1 point to
3WP54 6E REASONS USING DEVELOPMENT KIT The Development Kit is especially useful for customers who are developing their firmware. Below are the re
4WP54 6E PORTING OpenWRT FIRMWARE OVER TO WP54 6E Guide on how to port OpenWRT Firmware over to WP54 Note 1. Your current Compex loader version i
5WP54 6E ======================================================= |BusyBox v1.2.1 (2006.11.28-09:32+0000) Built-in shell (ash) |Enter 'help&
6WP54 6E PORTING OWN FIRMWARE OVER TO WP54 6E To port over your own firmware over to WP54 6E, you will need to have the drivers to support the
7WP54 6E CONFIGURATION AND INSTALLATION (WP54 6E) The following is the GPIO Bit mapping specific to the Compex WP54 6E. GPIO Bit Mapping The Com
8WP54 6E Interface Connectors The Compex WP54 6E interface connector pin assignments and signal descriptions are included in the following sectio
Comments to this Manuals